
Kenwood TS 950  Power On Funktions
Please notice that all functions only work if you switch off radio first.
Please push the named buttoms to start function when switching on the radio:

SUB : SUB receiver capable of scanning,to SUB-scan push and hold the SUB-key
and press than the scan key

ENT : Set up ch. 90-99 as amateur band vfos 160-10 m band possible.each
memory vfo will accept direct frequencie entry.(like ICOM band stack memory)

5+M-VFO  : set up ch.80-89 to accept any memory data

RX/A : Turn ON/OFF SUB receiver marker on SM 230 Monitor in 100 kHz/250kHz
and 25kHz sweep mode.

IC+COMP  : stop transmit if Ic exceeds 1,7 A. Power output limited to 10 Watt

8.83 + RIT : Both 8.83 MHz and 455 kHz IF Filters are selectable on
transmit. Each memory channel is also capable of storing this setting.

Geneal Coverage TX : cutting D 17 provides genearl coverage transmit

Memory protect: Cutting D 129 on control unit protects memory contents from
beeing erased.

Write protect : Cutting D 18 on Control Unit write protects all memory
channels.

73 from Hanno DG8JZ